NEC NEAX2400 IPX Programming Manual page 326

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

ASYD - System Data 1, Index 65. Assign the number of routes in the system.

ANPD - Reserve a number level for outgoing trunk access. Assign for Normal (N) and Hooking (H).

Assign NND in accordance with a predetermined numbering scheme.

ASPA - Assign the access code as assigned in ANPD above. Type of Service, SRV = OGC (Outgoing

Call) Outgoing Trunk. Assign the route number associated with the access code.

ARTD - Assign the DOD route as shown below:

GROUND START:

ATRK - Assign the LENs, DOD Trunk Route Number), Trunk Number, and Tenant Number.

MBTK - Assign the Make Idle status to the DOD trunks.

ARSC - The Route Restriction Class must be constructed via RRI: 3, direct access, to allow the station

access to the involved routes.

FCCS Programming

This data setting describes only the additional or replacement commands used to activate FCCS

services. When used as an FCCS feature, these commands replace the non-network commands (for

example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending

on the node.

ANPDL - Reserve a number level for outgoing trunk access. Assign for Normal (N) and Hooking (H).

Assign NND in accordance with a predetermined numbering scheme.

ASPAL - Assign the access code as assigned in ANPD above. Type of Service, SRV = OGC

(Outgoing Call) Outgoing Trunk. Assign the logical route number associated with the access code.

ARTDN - Assign the DOD route as shown below:

GROUND START:

ARSCN - The Route Restriction Class must be constructed via RRI: 3, direct access, to allow the

station access to the involved routes.

When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required

in addition to ASYDL or ASYDN.

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1

Direct Outward Dialing (DOD)