Table of Contents
Advertisement
Service Conditions
1.
The number of Internal Zone Paging groups is a maximum of 99 groups for each tenant.
term
2.
Each D
can be a member of multiple Internal Zone Paging groups.
3.
A maximum of 255 groups per system can be simultaneously paged using this feature.
4.
This feature is activated to idle stations in an Internal Zone Paging group.
5.
When all INTERNAL ZONE PAGING groups are busy, Busy Tone is sent.
6.
This service is not available from the Attendant Console, Central Office and Tie Line.
term
7.
If all D
s in the designated group are unavailable, a Busy Tone will be sent.
8.
When originating a call (or answering an incoming call) from a multi (sub) line on the D
INTERNAL ZONE PAGING, the voice call to the prime line stops and becomes idle, and the path on the
multi line is established. Even if the call is completed, the voice call is not established again.
9.
When a user cancels this feature with a held call, the user is recalled.
10.
A maximum number of 24 D
11.
A maximum of four stations is allowed INTERNAL ZONE PAGING in a Group of LEN (Level0-Level7).
12.
If a station in the paged group is busy when the INTERNAL ZONE PAGING call is originated, the station
is not called/recalled even if the station becomes idle later.
13.
After a station in the paged group answers the INTERNAL ZONE PAGING call, ringing at the other
member stations stop and two-way conversation starts.
14.
While member stations are paged by INTERNAL ZONE PAGING call, the prime lines of stations in the
group are busy status. Thus, the stations cannot be received another call from station, tie line, C.O. line or
Attendant Consoles during paging.
15.
When a prime line of a station in the paged group is a sub line of another D
term
another D
or light).
16.
To use this feature, either the PA-16ELCJ or the PA-16ELCJ-B circuit cards is required.
17.
This feature is not available for the IMG HDS Release IIIA, IV, and V software.
18.
The user can page any INTERNAL ZONE PAGING groups in the FCCS network via FCCS link using
this feature.
IZP Group A
term
D
term
D
term
/Analog Station
D
19.
An Internal Zone Paging group can consist of the D
group cannot be comprised of the D
20.
The maximum number of INTERNAL ZONE PAGING group per FCCS network is 255 groups.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Internal Zone Paging
term
s can be set this feature in a group.
cannot be affected by the INTERNAL ZONE PAGING call (the sub line key does not flash
PBX
N EC
term
D
NE C
N EC
term
N EC
/Analog Station
FCCS
term
stations accommodated in the same node. (The
s in different nodes.)
term
called by
term
, the sub line assigned to
PBX
IZP Group B
N EC
term
D
NE C
term
D
Page 419
I-21
Advertisement
Table of Contents
