Table of Contents
Advertisement
Interactions (cont'd)
9.
A calling station, Attendant Console, or trunk can successfully activate EXECUTIVE RIGHT-OF-WAY
[E-1], CALL WAITING-ORIGINATING [C-31], CALL WAITING-TERMINATING [C-12], or BUSY
VERIFICATION [B-3] after having been Call Forwarded and having received busy tone. (A trunk cannot
activate EXECUTIVE RIGHT-OF-WAY [E-1] or BUSY VERIFICATION [B-3]); ASYD - System Data
1, Index 69 = 1, Bit 5 = 1.
Programming
STEP 1:
ASYD - System Data 1, Index 5, Bit 0. Are access codes for CALL FORWARDING-BUSY LINE and
CALL FORWARDING-DON'T ANSWER the same or separate? 0/1: Same/Separate.
System Data 1, Index 69, Bit 7, and System Data 1, Index 5, Bits 1~3 for MULTIPLE CALL
FORWARDING.
STEP 2:
ANPD - Reserve a number level for feature access and cancel. Assign Connection Index, CI = N, H,
B; Normal, Hooking, and Busy (applicable to any feature assigned to this level). Assign NND in
accordance with a predetermined numbering plan.
STEP 3:
ASPA - Assign an access code to CALL FORWARDING-BUSY LINE Entry, SID = 10 and to CALL
FORWARDING-BUSY LINE Cancel, SID = 11. Assign Connection Status Index (CI) for Normal (N)
service.
STEP 4:
ASFC - Assign the stations to receive CALL FORWARDING-BUSY LINE a Service Feature Class
that allows SFI = 9.
STEP 5:
AKYD - For D
line/feature key. Assign Type:Function:CALL FORWARDING-BUSY LINE [1].
STEP 6:
ATNR - Allow tenant-to-tenant connection for Inter and Intra-tenant connections. Assign Tenant
Restriction Index (TRI) = 1. For this feature to be set by the Attendant Console assignment, assign TRI
= 3 for Inter and Intra-Tenant connection via the Attendant Console. This allows a station in one tenant
to be Call Forwarded to a station in the same or different tenant. Also assign TRI = 0, station-to-station
calling.
STEP 7:
ACFO - For tenant-wide CALL FORWARDING-BUSY LINE of an incoming DID and DIT calls,
assign CF = 1 for a destination (CFI) of either the Attendant Console or station.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - This Data must be assigned to all the nodes set Call Forwarding service.
System Data 1, Index 640: Assign the Fusion Point Code (FPC) of the node providing the attendant
console.
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
The data of the ASFC command is assigned to the node set Call Forwarding service.
Note 2:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - Busy Line
term
sets, CALL FORWARDING-BUSY LINE may be assigned to a programmable
Note 1
C-2
Page 113
Advertisement
Table of Contents
