Table of Contents
Advertisement
Interactions (cont'd)
3.
DAY/NIGHT CLASS OF SERVICE affects the following restrictions:
a.) Route Restriction Class (ARSC)
b.) Service Feature Class (ASFC)
c.) Toll Restrictions (ATDP)
d.) Tenant Restrictions (ATNR)
4.
When TRUNK ANSWER FROM ANY STATION (TAS) [T-8] is installed, a station's Night RSC must
allow access to the IC trunks. Also, the Night SFC must allow TAS, SFI 13.
Programming
STEP 1:
ASYD - System Data 1, Index 75, Bit 0. Are Route Restriction Class Pattern (ARSC command) tables
to be developed for both Day and Night? 0/1: No/Yes.
System Data 1, Index 75, Bit 1. Are the Service Feature Class Pattern (ASFC command) tables to be
developed for both Day and Night? 0/1: No/Yes.
System Data 1, Index 75, Bit 2. Are the Tenant Restriction Data Pattern (ATNR command) tables to be
developed for both Day and Night? 0/1: No/Yes.
System Data 1, Index 75, Bit 3. Are the Toll Restriction Data (ATDP command) tables to be developed
for both Day and Night? 0/1: No/Yes.
System Data 1, Index 77, Bit 0. Is Day/Night mode change accomplished by removing the handset
from the ATTCON? 0/1: No/Yes.
System Data 1, Index 229, Bit 3. System message printout on changeover of the Day/Night mode? 0/1:
Out/In Service.
System Data 2, Index 2, Bit 2. Is this a Primary ATTCON system? 0/1: No/Yes. (When Primary goes
into Night, tenant goes into Night).
System Data 2, Index 2, Bit 3. Is this a normal ATTCON system? 0/1: No/Yes. (When all Attendant
Consoles go into Night, tenant goes into Night).
STEP 2:
ASFC - Assign this command for both the Day and Night tables.
STEP 3:
ARSC - Assign this command for both the Day and Night tables.
STEP 4:
ATNR - Assign this command for both the Day and Night tables.
STEP 5:
ATDP - Assign this command for both the Day and Night tables.
STEP 6:
ASID - If ATTENDANT NIGHT TRANSFER
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - This data must be set to all the nodes.
System Data 1, Index 640. Assign the node of attendant console.
STEP 2:
ASPAL - These data must be set to the node that calls the attendant.
SRV:
SSC
SID:
2=Operator Call
FPC:
FPC of the node accommodates the attendant console
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Day/Night Class of Service
Note
[A-19]
is needed, assign this command.
D-15
Page 291
Advertisement
Table of Contents
