Table of Contents
Advertisement
Service Conditions (cont'd)
5.
There is no limitation to the number of stations that can set the CALL FORWARDING - DON'T
ANSWER simultaneously.
6.
CALL FORWARDING - DON'T ANSWER can be provided on either a tenant or an individual basis.
7.
Individual CALL FORWARDING - DON'T ANSWER takes precedence over tenant basis Call
Forwarding.
8.
Call Forwarding on a tenant basis allows direct incoming trunk calls that encounter a Don't Answer
condition to be forwarded to a predetermined station or the ATTENDANT CONSOLE [A-3].
9.
The operator answering a Call Forwarding call can identify the called telephone number on the
ATTENDANT CONSOLE [A-3] display.
10.
CALL FORWARDING - DON'T ANSWER from the Attendant is only activated after pressing the
RELEASE key.
11.
If the station's own telephone number is set for CALL FORWARDING - DON'T ANSWER, then this
feature is changed to CALLING PARTY RECOGNITION SERVICE (CALL FORWARDING - DON'T
ANSWER [C-103]).
12.
When the called station does not answer for a predetermined time interval, stations are assigned this
feature according to the TENANT SERVICE [T-12] class of the calling and destination stations. In the
following cases, when the calling station and destination station are restricted by TENANT SERVICE [T-
12] class, this feature is not activated, and the called station continues to ring:
a.) when the station called is setting CALL FORWARDING - DON'T ANSWER,
b.) when a station holding an original call (station or trunk) on CONSULTATION HOLD [C-17]
places a call to a station setting CALL FORWARDING - DON'T ANSWER.
13.
Call Transfer - Attendant (Trunk): Trunk calls transferred by the Attendant are assigned this feature when
the called station does not answer for a predetermined time interval according to Route Restriction Class
of the trunk and the destination stations. When restricted by Route Restriction Class, this feature is not
activated, and the called station continues to ring.
14.
Call Transfer - Attendant (Station): Station calls transferred by the Attendant are assigned this feature
when the called station does not answer for a predetermined time interval according to TENANT
SERVICE [T-12] class of the originating and destination stations. When restricted by Tenant Service
class, this feature is not activated, and the called station continues to ring.
15.
Speed Calling List numbers may be programmed as the destination telephone number. This permits the
sent digits to exceed the 12-digit maximum.
16.
CALL FORWARDING - DON'T ANSWER data remains in the data memory, even if the system or LP is
reinitialized.
17.
SPLIT CALL FORWARDING [S-99]: When a call is forwarded to the parties predesignated by SPLIT
CALL FORWARDING [S-99], service conditions are the same as described in items 12, 13, and 14.
18.
When a call is transferred from the Attendant to a station that has set CALL FORWARDING - DON'T
ANSWER, this feature may be restricted or activated according to System Data (Sys 2, Index 6, Bit 7).
19.
A call can be forwarded to an Attendant Console in the remote node via FCCS link.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - Don't Answer
C-3
Page 121
Advertisement
Table of Contents
