NEC NEAX2400 IPX Programming Manual page 828

U-3
General Description
This feature permits dialed numbers to be transmitted via a sender, a device that will automatically add or delete the
necessary number of digits or perform any necessary conversions.
Operating Procedure
No manual operation is required.
Service Conditions
1. For incoming connections, digits may be deleted according to the route involved. A maximum of 4 digits
may be added (including the access code).
2. For outgoing connections, digits may be added/deleted according to the route involved. A maximum of 24
digits may be deleted, and a maximum of 4 may be added (including the access code).
3. LEAST-COST ROUTING [L-5]: Digits may be added/deleted according to the route involved and the
dialed digits. A maximum of 24 digits may be deleted, and a maximum of 24 may be added, consisting of
either digits or 2.8 second pauses.
Interactions
1. For features requiring digit translation, refer to the specific feature programming description.
2. The ASTP, AOSP, and AISP commands operate to translate incoming TIE Line digits that are received
by the register and then sent to the opposite PBX via UNIVERSAL SENDER. The ANND command is
used like the AMND command. It tells the system how many digits the register is to expect for a specific
route. The UNIVERSAL SENDER then sends the digits to the opposite PBX. Features requiring the
UNIVERSAL SENDER are:
ATTENDANT CONSOLE
ATTENDANT KEY PAD
AUTOMATIC TRUNK TEST
CALL FORWARDING-OUTSIDE
LEAST-COST ROUTING-3/6 DIGIT
OUTGOING TRUNK QUEUING
OFF-HOOK QUEUING
PUSHBUTTON CALLING
PUSHBUTTON-TO-ROTARY CONVERSION
SPEED CALLING
TOLL RESTRICTION-3/6-DIGIT
Programming
STEP 1: ATRK - Assign these LENs as sender Route 905, Trunk. A LEN consists of the following:
Level numbers for the sender trunks are 4-7.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Universal Sender
Universal Sender
Module Group Unit
XX X
[A-3]
[A-4]
[A-21]
[C-28]
[L-5]
[O-2]
[O-7]
[P-4]
[P-6]
[S-3, 21, 23]
[T-7]
Group Level
XX X
U-3
Page 785