Table of Contents
Advertisement
P-57
P-57
General Description
This feature temporarily restricts telephones from making unauthorized calls by dialing a special access code when
users are away from their seats.
Operating Procedure
To set PAD LOCK from the station
1.
Lift the handset and receive dial tone.
2.
Dial PAD LOCK access code and receive special dial tone.
3.
Dial Authorization Code and receive service set tone.
4.
Restore the handset.
To cancel PAD LOCK from the station
1.
Lift the handset and receive dial tone.
2.
Dial PAD LOCK cancel code and receive special dial tone.
3.
Dial Authorization Code and receive service set tone.
4.
Restore the handset.
Service Conditions
1.
This feature restricts telephones from making C.O. outgoing calls and/or terminating calls from C.O.
trunks, stations, and attendant consoles. Stations in Pad Lock status are able to place station-to-station calls
and outgoing calls using attendant assisted calling.
2.
If the station under Pad Lock status dials a C.O. line access code, the station is rerouted to reorder tone or
the Attendant Console.
3.
Calls to stations in PAD LOCK status will receive reorder tone or, on a tenant basis, can be assigned to
transfer to the Attendant Console.
4.
PAD LOCK status will continue unless it is cancelled.
5.
Stations are assigned this feature via Class of Service.
6.
This feature is set/cancelled from the station only. The Attendant Console cannot set or cancel this feature.
term
7.
If a D
is in PAD LOCK status, the My Line and Sub Line are restricted.
8.
When the station in PAD LOCK status attempts to set PAD LOCK again, it is connected to reorder tone
(RST/REST is displayed on the D
Programming
STEP 1:
ASYD - Assign the data associated with Authorization Code service. System Data 1, Index 43, Bit 2.
Send SST after dialing the access code for PAD LOCK. 0/1=Out/In Service.
STEP 2:
ASPA - For SRV=SSC (Service Code) SID=42, assign the access code for Dial Access to lock. For
SRV=SSCA (Service Code Appendix) SIDA=85, assign the access code for Dial Access to unlock.
STEP 3:
ASFC - For stations allowed Authorization Code (PAD LOCK), assign a Class of Service that allows
SFI 27 (Authorization Code), and assign a Class of Service that allows SFI 125 (PAD LOCK).
STEP 4:
AMND - For Tenant 0, assign the Destination Code (DC) as the first digit of Authorization Code and
Maximum Necessary Digits (MND) of Authorization Code.
Page 608
Pad Lock
Pad Lock
term
).
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
