Table of Contents
Advertisement
C-94
Service Conditions (cont'd)
a.) Pattern 1 (ASYD, SYS2, Index 15, b4= 0)
XX - XX - XXXXX - XXXXX
This pattern is used when a unified numbering plan is in use within the CCIS network.
b.) Pattern 2 (ASYD, SYS2, Index 15, b4 = 1)
XX - XX - XXXXX - XXXXX - #
This pattern is used when a unified numbering plan is not in use within the CCIS network.
2.
Since the numbering plan at the transfer destination cannot be identified in this case, dialing the digit
receive completion ID code (#) must be dialed.
3.
If the transferring telephone number of the transfer target telephone number dialed by the attendant is a
wrong number, the attendant receives Reorder tone. For example:
a.) When an unobtainable number has been dialed.
b.) When the transferring station or the transfer target station is restricted from the service.
c.) When the number dialed is double registered.
4.
A transferring telephone number is a maximum of 8 digits.
5.
When the transferring station is an ATTCON, service can be set by its individual Attendant Number but
the call is not transferred to the designated target station.
Programming
STEP 1:
ASYD - System 2, Index 15, bit 4: The office which determines the target number. 0/1: Service
executing office/office accommodating the transferring station.
STEP 2:
ASAT - Assign an individual Attendant access number for each Attendant Console.
STEP 3:
ANPD - Assign the minimum necessary number of digits for the first number of the access code for
Call Forwarding.
STEP 4:
ASPA - Assign the access code for Call Forwarding.
CI = N, SRV = SSC (Service Code), SID = 8, Call Forwarding - All Calls (Entry)
CI = N, SRV = SSC (Service Code), SID = 9, Call Forwarding - All Calls (Cancel)
CI = N, SRV = SSC (Service Code), SID = 10, Call Forwarding - Busy Line (Entry)
CI = N, SRV = SSC (Service Code), SID = 11, Call Forwarding - Busy Line (Cancel)
CI = N, SRV = SSC (Service Code), SID = 12, Call Forwarding - Don't Answer (Entry)
CI = N, SRV = SSC (Service Code), SID = 13, Call Forwarding - Don't Answer (Cancel)
STEP 5:
ARNP - RT0: Self Office Identification Code for CCIS. If RT0 is assigned, service set tone will not be
heard.
Page 876
Call Forwarding Assignment - Attendant - CCIS
Transfer target station
Transferring station
Tenant number of transferring station
Access Code for Call Forwarding
Digit receive completion ID code
Transfer target
Transferring station
Tenant number of transferring station
Access Code for Call Forwarding
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
