NEC NEAX2400 IPX Programming Manual page 795

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

Programming (cont'd)

DAY/NIGHT:D (Day)

Repeat these same assignments for Digit Codes "93" through "99" to allow all local office codes.

To allow Area Codes 718, 212, and 201, repeat the ATDP command for the following Digit Codes:

To allow office codes 239, 465, and 798 within Area Code 914, assign the ATDP command as follows:

DAY/NIGHT: D (Day)

AARP Command-

Repeat these same assignments for the following Digit Codes:

This allows office codes 239, 465, and 798 within Area Code 914. All other office codes are

automatically restricted.

This method of assignment allows office codes 239, 465, and 798 to any Area Code that is assigned as TDI

= 2 in ATDP. For example, if the assignment for Area Code 718 was changed from TDI = 1 (allowed) to

TDI = 2, then the office codes 239, 465, & 798 would also be allowed for Area Code 718.

If different Office Codes are to be allowed in the 718 Area Code (for example 623 and 567), then the

assignments for Area Codes 914 and 718 must be made as follows:

ATDP Command-

DAY/NIGHT: D (Day)

DAY/NIGHT: D (Day)

This tells the system to check AARP tables for restrictions for all Area Codes beginning with 9 and 7.

AARP Command-

Toll Restriction - 3/6-Digit

1(Connection is Allowed)

TDI: 1 (Connection is Allowed)

O (Outgoing Connection)

2 (Go to AARP Command)

6 (Begin restriction after 91914, i.e; the 6th digit dialed.)

O (Outgoing Connection)

2 (Go to AARP Command)

O (Outgoing Connection)

2 (Go to AARP Command)

1 (Connection is Allowed)

1 (Connection is Allowed)

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1