Table of Contents
Advertisement
D-149
Service Conditions (cont'd)
6.
When the user calls the DSS station by SPEED CALLING - ONE TOUCH, or transfers the call to the DSS
station, and the DSS station is the member of the UCD [U-1] or station hunting group, the call follows the
UCD or the hunting operation. (If the MCI is valid, the message is sent out.)
7.
The user can recognize the idle/busy status of the accommodated stations by the lamps. The left lamp (red)
lights when busy and goes out when idle and shows incoming call, hold, etc. The right lamp (green) shows
I-used, I-hold, etc.
8.
The DSS console and the connected D
belong to the same module group.
9.
A ringing line is programmable for line keys when the device is used as an Add-On Module (ADM) only.
For example, if Station A calls Station B, and Station B shows up on a DSS Console, the indication at the
DSS Console is a flashing red LED (not ringing). Even if this line is programmed to ring, it will not.
ADM Function
1.
The 60 keys are used as the feature keys. The key layout of the DSS console is as follows:
2.
On the 25th key and after, MESSAGE REMINDER [M-19], D
Page 316
Direct Station Selection (DSS) Console
term
may be accommodated in the different circuit card, but should
00
01
02
06
07
08
12
13
14
18
19
20
24
25
26
30
31
32
36
37
38
42
43
44
48
49
50
54
55
56
03
04
05
09
10
11
15
16
17
21
22
23
27
28
29
33
34
35
39
40
41
45
46
47
51
52
53
57
58
59
term
my line/prime line cannot be assigned.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
