Table of Contents
Advertisement
A-59
FCCS Programming (cont'd)
EQP:
Announcement Equipment Number
0 = Dead Level
1 = Unused Number
2-15 = Announcement service
C:
Duration of Connection
0 = Disconnection occurs in 30 seconds
1 = Connection is held until the station releases. See the requirements of the application for
R:
Sending RBT
0/1 = Yes/No
A:
Answer Signal Sending (Answer from the incoming trunk)
0 = No/Yes Normally assign data "1".
M:
Multiple Connection
0/1 = Single Connection/Multiple Connection
LGRT: Logical Route
TK:
Trunk Number
STEP 3:
ARRCN - This data must be assigned to the NCN.
Release the restriction between the terminating trunk and the announcement trunk.
STEP 4:
ARSCN - This data must be assigned to the NCN.
Release the restriction between the announcement trunk and the station.
The current command data shown is set to all nodes using the service: ASTD, ARTD, ATRK, MBTK
Note:
Page 52
Announcement Service - Attendant
the announcement equipment. For Dead level applications, data 0 is assigned.
*Not necessary for "M = 1"
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
