Table of Contents
Advertisement
C-69
Programming (cont'd)
STEP 4:
ATRK - Assign the LENs. Announcement Trunk Route Number, Trunk Number, and Tenant Number.
Assign one or more trunks to a specific route used to connect to an announcement machine.
STEP 5:
MBTK - Assign the Make Idle status to the announcement trunk.
STEP 6:
ADSL - Assign SN=1 (Originating; DT Connection) and FKY=2 (Call Forwarding - All Calls; FDA).
This command is used for assigning the function for each soft key.
STEP 7:
ARRC - If a TIE Line, DID or REMOTE ACCESS TO PBX [R-2] connection to the Announcement
Service trunk is required, allow trunk-to-trunk connection using ARI-D-RES, Direct Connection.
STEP 8:
AAED - Used to assign announcement equipment.
Assign:
TN:
Tenant Number
EQP:
Announcement Equipment Number
0: Dead Level
1: Unused Number (LCR OPR not programmed)
2: Available
3: Available
4: Outgoing Trunk Group Busy Announcement
5: Available
6: Available
7: Outgoing Route Restriction Announcement
8-15: Available for ANNOUNCEMENT SERVICE [A-15] applications
RT, TK:
C:
R:
A:
M:
Page 228
Call Forwarding - All Calls - Announcement
Route and trunk number of the trunk connected to the announcement equipment
Duration of Connection, 0/1: Disconnection occurs in 30 seconds/ the connection is held
until the station releases. See the requirements of the announcement equipment.
Sending RBT, 0/1: Sending RBT/Not Sending RBT. Normally assign data "0".
Answer Signal Sending, 0/1: No answer from Incoming trunk/Answer from Incoming
trunk. Normally assign data "0". No answer signal is sent to the C.O. Therefore, calling
party will not be billed for the call.
Multiple Connection 0/1: Single Connection/Multiple Connection. See the requirements
of the announcement equipment.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
