Table of Contents
Advertisement
E-26
Expanded Multiple Line Operation - D
General Description
This feature allows operation of whichever lines from ELC card(s) in the same IMG or in different IMGs in the same
term
node, as a D
's programmable Multiple Lines (My Line + Prime Line/Sub Lines). While Multiple Line Operation
term
- D
[M-20] only allows such a programming within the reach of ELC card(s) in the same IMG, this feature
enables the Multiple Line Operation beyond the reach of a single IMG (though the ELCs cannot be in different
nodes).
To use Multiple Lines beyond different IMGs, the Dterm My Line must be accommodated on the PA-
Note:
16ELCJB-B card. For details, refer to the figure (and Service Conditions) below:
term
D
PA-16ELCJB-B
ELC circuit card other
than PA-16ELCJB-B
Operating Procedure
No manual operation is required.
Service Conditions
1.
To use this feature (operation of Multiple Lines beyond different IMGs), a PA-16ELCJB-B circuit card is
required.
2.
Depending on the switch setting on PA-16ELCJB-B, the assignable Multiple Lines vary.
a.) PA-16ELCJB-B, SW10, Element 1 = ON: A D
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Expanded Multiple Line Operation - D
Node A
IMG 0
A
term
D
C
term
D
B
IMG 1/2/3
FCCS / Tie Line
term
D
D
term
My Line, accommodated on this card, and the
other Lines (other analog telephone/D
the same IMG.
term
Node B
term
D
E
term
Note
E-26
term
) must be in
Page 345
Advertisement
Table of Contents
