Table of Contents
Advertisement
A-45
Operating Procedure (cont'd)
5.
Stations (a) and (b) both go on-hook
6.
Station (b) answers; Station (b) and Subscriber (c) are connected with each other.
If the Attendant presses the BV key instead of the RELEASE key, the Attendant bridges into the Station (b)
Note 1:
side and, as a result, a three-way connection is set up. In this case, both (a) and (b) are bridged into the
connection. The Attendant sets Camp-On by pressing the RELEASE key.
Instead of on-hook by Stations (a) and (b), if (b) switch hook flashes and dials the Call Hold Access Code,
Note 2:
(b) can answer Subscriber (c) (C.O.line party), and (a) is held on the line.
If (b) switch hook flashes and dials the Call Hold Access Code once again, (b) can return to the connection
with (a). In this case, Subscriber (c) is held on the C.O.line.
Service Conditions
1.
Only one incoming call can be camped on to a particular station at any given time. Multiple CAMP-ON
is not allowed.
2.
Calls that remain camped-on for longer than the predetermined time will initiate AUTOMATIC RECALL
- CCIS [A-71].
Page 804
Attendant Camp-On with Tone Indication - CCIS
Note 2
TELEPHONE
CO Line
ATT
STN (a)
CCIS
[Node A]
CO Line
ATT
STN (a)
CCIS
[Node A]
; (b) is rung, and (c) receives ringback tone.
PUBLIC
SWITCHED
NETWORK
RBT
Subscriber (c)
Ringback Tone
STN (b)
[Node B]
Ringing
PUBLIC
SWITCHED
TELEPHONE
NETWORK
Subscriber (c)
STN (b)
[Node B]
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
