Table of Contents
Advertisement
Service Conditions (cont'd)
EXCLUSIVE HOLD - D
NON-EXCLUSIVE HOLD - D
OFF-HOOK QUEUING
OUTGOING TRUNK QUEUING
PRIVACY - D
PRIVACY RELEASE
THREE-WAY CALLING
VOICE CALL
VOICE CALL - D
Data Call through Data Adapter / Data Call through Data Module
Note:
In any of the above instances, the calling station will receive reorder tone.
4.
If one party disconnects after the THREE-WAY CALLING [T-2] has been established, the other two
parties will remain connected.
5.
EXECUTIVE RIGHT-OF-WAY can also be accessed via the dial pad (access code) or SPEED CALLING
- ONE TOUCH - D
6.
The maximum number of simultaneous executive overrides allowable is dependent on the number of
conference function trunks in the system. (Conference function is included in TSW and MUX circuit
cards.)
7.
This feature can be denied on DICTATION ACCESS [D-3] and PAGING ACCESS [P-1, 28] connections
through programming in system data.
8.
If the called station has activated CALL FORWARDING - ALL CALLS [C-5] and the forwarded-to
station is busy, EXECUTIVE RIGHT-OF-WAY will bridge into the forwarded-to station.
9.
It is possible, via system data, to disable the sending of a warning tone during an EXECUTIVE RIGHT-
OF-WAY connection. Normally, the two-burst warning tone is sent when the connection is initiated.
10.
If the called station line has a party on CALL HOLD [C-6], override is not allowed to the called station
line. Also override to a station line in CALL HOLD [C-6] is denied and reorder tone is provided.
Terminating override calls are denied when the called party has another party in a CONSULTATION
HOLD [C-17] condition.
11.
If the called station is maintenance busy and EXECUTIVE RIGHT-OF-WAY is invoked, override is
denied and reorder tone is returned to the calling station.
12.
The node accommodating the called station requires Conference Trunk (CFT) function in the FCCS
network.
Programming
STEP 1:
ASYD - System Data 1, Index 70, Bit 7. Send Warning Tone to interrupted parties when Executive
Right-of-Way service is in operation 0/1: Required/Not Required.
System Data 2, Index 0, Bit 1. Busy station service. Assign data "1".
STEP 2:
ANPD - Assign first digit of access code for EXECUTIVE RIGHT-OF-WAY.
STEP 3:
ASPA - Assign an access code for EXECUTIVE RIGHT-OF-WAY, SID 4 for Connection Status
Index (CI) of Busy (B) and Hooking (H).
STEP 4:
ASFC - Assign Service Feature Indexes of 3 (EXECUTIVE RIGHT-OF-WAY calling side), 4
(EXECUTIVE RIGHT-OF-WAY called side), and 11 (Data Line Security).
STEP 5:
AKYD - Assign EXECUTIVE RIGHT-OF-WAY to a programmable line/feature key. Assign
Type:Function:EXECUTIVE RIGHT- OF- WAY [3].
STEP 6:
ADSL - Assign SN=3 (Called Station is Busy) and FKY=3 (Executive Right-of-Way; BV).
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Executive Right-of-Way - D
term
term
term
term
term
[S-26D].
term
[E-4D]
[N-7D]
[O-7, O-11]
[O-2, O-2D]
[P-14D]
[P-18]
[T-2, T-2D]
[V-2, V-7]
[V-2D]
E-1D
Page 337
Advertisement
Table of Contents
