Table of Contents
Advertisement
D-3
Interactions (cont'd)
4.
If the station side is used to connect DICTATION ACCESS, STATION HUNTING [S-7, 8, 9] will
provide capabilities to connect multiple dictation machines to the system.
Programming
STEP 1:
ANPD - Reserve a number level for station access. Assign for Normal (N) and Hooking (H). Assign
NND in accordance with a predetermined numbering plan.
STEP 2:
ASPA - Assign an access code to the DICTATION ACCESS trunk, SRV = OGC (Outgoing Call).
Correlate access code to route. One trunk per announcement route. Assign CI: of N and H.
STEP 3:
ARTD - Assign the DICTATION ACCESS route as follows:
RT:1
1-OSGS
8-RLP
STEP 4:
ATRK - Assign the LENs, DICTATION ACCESS trunk route number, trunk number, and tenant
number.
STEP 5:
MBTK - Assign the Make Idle status to the DICTATION ACCESS trunk.
Note:
If supervision is required, use the first two circuits of the 16COT circuit card. Move the switch on 16COT
to PGT.
STEP 6:
ARRC - If TIE Line or Remote Access connection to DICTATION ACCESS trunk is required, allow
trunk-to-trunk connection using ARI-D-RES, Direct Connection.
The DICTATION ACCESS equipment may be installed on the line side of the PBX. The connection would
Note:
then be considered as a STATION-TO-STATION CALLING [S-11].
STEP 7:
ARSC - Allow RRI 3 to the RSC's allowed access to Dictation.
Page 272
Dictation Access
:2
2-0NSG
:3
:2
44-PRV
:1
16 COT
5-TF
:1
6-TCL
CKT 0
Voice Tip
Voice Ring
CKT 1
Supervisory Ground
Ring, not used
:10
7-L/T
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
:1
Advertisement
Table of Contents
