Table of Contents
Advertisement
Service Conditions (cont'd)
4.
Regarding the ANI information identifier, the numbers 0, 2, 3, 4 and 5 are output only when the
information is sent from Central Office.
Meanings of ANI information identifier numbers:
Note:
0 = Not output
1 = Display
2 = Not display
3 = Not provide service
4 = Outgoing C.O. call
5 = Service Condition
5.
When an office receiving a calling number from Central Office extends the call to another office through
CCIS and charging is performed at the extended office, the maximum calling number is 16 digits.
However, only when ANI information identifier sent from Central Office is 1 (Display), the calling
number is output.
6.
This service is available when using CENTRALIZED BILLING – CCIS [C-55]. (A main office receives
charging information from its remote office as it received. However, if the main office makes this service
invalid, the information in the expanded area is not output but transferred by using current identifiers
(outgoing: KA, incoming: KE, both station: KB).
The following is the table showing relationship between a main office and a remote office when remote
charging is established.
TRANSFER FORMAT FROM A
REMOTE OFFICE / OUTPUT FORMAT
FROM A MAIN OFFICE
This service is activated.
This service is not activated.
7.
This service is not supported in offices performing remote charging.
Programming
Also see TRUNK LINE APPEARANCE
term
a D
line/feature key.
STEP 1:
ASYD - System Data 1, Index 241, Bit 6. 0/1 = When the length of Caller ID exceeds the limit, only
the former/latter part of data appears on the LCD.
System Data 1, Index 390, Bit 0. Caller ID display pattern on the LCD. 0/1 = Calling Number/Calling
Name has priority.
System Data 1, Index 390, Bit 2. when using D
displaying Caller ID. 0/1 = Out/In service.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
SMDR Output Expansion - ANI/CPN
CURRENT TRANSFER
FORMAT
Expanded area information
ID is output only.
Information is output in
space.
Information is output in the
current format.
[T-23]
EXPANDED TRANSFER
FORMAT BY ACTIVATING THIS
Information is output in the
expanded format according to
system data of the main office. In
case information required to be
output at a main office is not in the
transfer format from a remote
office, information is output same
as the current transfer format.
Information in the expanded area is
not output but transferred in the
current format.
for information on how to accommodate C.O. line on
term
2-line LCD, the lower LCD can be used for
S-129
SERVICE
Page 729
Advertisement
Table of Contents
