Table of Contents
Advertisement
Operating Procedure (cont'd)
d.) A recorded message of the designated Message Number for ACD is automatically played back.
e.) Replace the handset to finish playback of the recorded message.
Note:
Even though the recording of a message has been finished, playback of the trunk cannot be accepted until
dubbing of the message to the remaining trunks is complete.
Service Conditions
1.
Any entry of RT, TK, UCD Controlling Station, and Message Number that has not been assigned results
in reorder tone (ROT) connection.
The values that each parameter can take fall into the ranges:
RT:
TK:
Message Number: 01 - 58
2.
The maximum recording length is 60 sec (30 sec in the case of UCD).
3.
This feature is not effective for trunks being dubbed or placed in busy.
4.
A user cannot record a message to a trunk in which a recording/dubbing is being made.
5.
When a user encounters Digital Announcement Trunk-All Busy, after dialing RT/TK/UCD Controlling
telephone number/Message Number from the terminal, the user hears a busy tone.
6.
After completion of dialing RT/TK/UCD Controlling telephone number/Message Number, a user hears
the service set tone. In this instance, if the designated trunk is making a dub or being dubbed, the dubbing
is stopped. When the user goes on-hook during the service set tone, the dubbing is also stopped.
7.
A message is recorded in the following sequence. As illustrated below, 1.5 sec after the service set tone
and 1 sec before going on-hook are not recorded.
SST
SST
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Multi Channel Recording - DAT
REPLAY START
Replay Time
(Time Display)
001 - 999
000 - 255
REC STARTS
NO TONE
1.5
sec
In 5 seconds
DDD
REC ENDS
MESSAGE
1
ON-HOOK
NO TONE
1.5
sec
M-48
Page 529
Advertisement
Table of Contents
