Table of Contents
Advertisement
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ANPDL - Reserve a number level for feature access and cancel. Assign Connection Index, CI = N, H,
B; Normal, Hooking, and Busy (applicable to any feature assigned to this level). Assign NND in
accordance with a predetermined numbering plan.
STEP 2:
ASPAL - Assign an access code to CALL FORWARDING-BUSY LINE Entry, SID = 10 and to
CALL FORWARDING-BUSY LINE Cancel, SID = 11. Assign Connection Status Index (CI) for
Normal (N) service.
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
System timers may be set on a network basis in ASYDN.
Note 2:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - Busy Line - Outside
Note 1
C-60
Page 223
Advertisement
Table of Contents
