Calling Party Number - Name Assignment And Display - NEC NEAX2400 IPX Programming Manual

Feature programming manual
Hide thumbs Also See for NEAX2400 IPX:
Table of Contents

Advertisement

C-157
C-157 Calling Party Number - Name Assignment and
General Description
This feature allows a user to assign the desired name for the calling number, which is provided by Central Office,
CCIS or ISDN feature, using the MAT command. The assigned name is displayed on the LCD of the D
Desk Console.
Operating Procedure
No manual operation is required.
Service Conditions
1.
When the calling number is not received, the assigned name cannot be displayed.
2.
The calling number for this feature is assigned to the parameter CID of ACID command. When only the
first part of the calling number is assigned to the CID, the corresponding name is applied to any calling
number that begins with the assigned number. For example, when "1471" is assigned to the CID, the
calling name assigned for the number is applied to any calling number that begins with 1471, such as 1471-
12-3456 or 1-471-234-5678.
3.
The following numbers cannot be assigned to the parameter CID of ACID command:
a.) The first part of the already assigned number.
b.) The number whose first part is the same as the already assigned number.
For example, when "123" is already assigned to the CID, such as number as "1", "12", and
"1234" cannot be assigned.
4.
When a calling number is sent via CCIS line, this feature is available for the first 16 digits only.
5.
The name display is available only when a call directly terminates to a D
calling number. For example, the assigned name is not displayed for the transferred call. However, in this
case, the assigned name appears after the transferring party (an Attendant Console or a station) is
disconnected.
6.
If forwarding a call via CALL FORWARDING - BUSY LINE [C-2]/DON'T ANSWER [C-3]/ALL
CALLS [C-5], the assigned name can be displayed only when the destination station is a D
7.
The assigned name cannot be displayed on the Attendant Console. Displaying the assigned name on Desk
Console is available.
8.
The assigned name cannot be output to the SMDR expanded area.
9.
A maximum of 10,000 names for the calling numbers can be assigned in a system. However, this amount
varies depending on the data capacity of CALL BLOCK [C-150] or the data memory capacity of the
system.
10.
This feature has priority over the current Caller ID service.
11.
The display for OAI service has priority over the display for this service.
Page 258

Calling Party Number - Name Assignment and Display

Display
term
from the trunk received the
term
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
term
and the
.

Advertisement

Table of Contents
loading

Table of Contents