Table of Contents
Advertisement
Programming (cont'd)
STEP 5:
ASHP - When the system accommodates multiple PA-CFTB circuit cards, assign a STATION
HUNTING - TERMINATING group for the stations programmed to LEN level 0 of each PA-CFTB
circuit card. For more details, see the figure below:
LV7
LV0
STEP 6:
AKYD - assign FKY 83 to any D
STEP 7:
ADSL - Assign SN=3 (STATION BUSY) and FKY=13 (THREE-WAY CALLING;CONF).
Assign FKY=83 (RETAIN CONFERENCE; RETAIN) to any D
RETAIN CONFERENCE feature.
This command is required for assigning the function to each soft key.
STEP 8:
ARSC - assign Restriction data between routes and the RSC used by the CFTB.
STEP 9:
ATNR - assign restriction data between tenants.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - This data must be assigned to the node set Add On Conference - 8 Party.
System Data 1, Index 527, bit 4 = 1
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Add On Conference - 8 Party
PA-CFTB
PA-CFTB
Pilot
term
Note
PA-CFTB
STATION HUNTING - CIRCULAR groups assigned by
ASHC command
STATION HUNTING - TERMINATING groups assigned by
ASHP command
s that require the use of the Retain Conference feature.
term
which require the use of the
A-121
Page 71
Advertisement
Table of Contents
