Table of Contents
Advertisement
S-99
General Description
This feature allows a station to set two different target stations for CALL FORWARDING-ALL CALLS
(FORWARD)/BUSY LINE (FORWARD-BY)/DON'T ANSWER (FORWARD-DA), depending on whether the
incoming call is from an internal station or an outside party (C.O. TIE, DID, etc.).
Operating Procedure
1.
Station A sets or is set for CALL FORWARDING-ALL CALLS/BUSY LINE/DON'T ANSWER. Station
B is set as the transfer destination for an incoming call from a station. Station C is set as the transfer
destination for an incoming call from an outside party.
2.
An incoming call from a station terminates to Station A. The call is transferred to Station B.
3.
An incoming call from an outside party terminates to Station A.
4.
The call is transferred to Station C.
For the transfer procedure, refer to the Operation Procedure of CALL FORWARDING-ALL CALLS [C-5],
Note 1:
CALL FORWARDING-BUSY LINE [C-2], or CALL FORWARDING-DON'T ANSWER [C-3].
The call may be transferred to Station B (transfer destination for an incoming call from a station),
Note 2:
depending on the route class data [ARTD, CDN 68:SCF] of the trunk involved.
To set SPLIT CALL FORWARDING using an access code
To set Call Forwarding from an individual station (Single-line Telephone)
1.
Setting Call Forwarding for an incoming call from a station:
a.) Lift the handset; receive dial tone.
b.) Dial the access code for FORWARD, FORWARD-BY, or FORWARD-DA for an incoming call
from a station; receive special dial tone.
c.) Dial the number of the desired target station; receive service set tone.
d.) Replace the handset.
2.
Setting Call Forwarding for an incoming call from an outside party:
a.) Lift the handset; receive dial tone.
b.) Dial the access code for FORWARD, FORWARD-BY, or FORWARD-DA for an incoming call
from an outside party; receive special dial tone.
c.) Dial the number of the desired target station; receive service set tone.
d.) Replace the handset.
To cancel Call Forwarding from an individual station (Single-line Telephone)
1.
Cancelling Call Forwarding for an incoming call from a station:
a.) Lift the handset; receive dial tone.
b.) Dial the cancel code for FORWARD, FORWARD-BY, or FORWARD-DA for an incoming call
from a station; receive special set dial tone.
c.) Replace the handset.
2.
Cancelling Call Forwarding for an incoming call from an outside party:
a.) Lift the handset; receive dial tone.
b.) Dial the cancel code for FORWARD, FORWARD-BY, or FORWARD-DA for an incoming call
from an outside party; receive special set tone.
c.) Replace the handset.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Split Call Forwarding
Split Call Forwarding
Note 1
Note 2
S-99
Note 1
Page 715
Advertisement
Table of Contents
