Table of Contents
Advertisement
R-54
General Description
This feature allows a station user to set/cancel the following forwarding features from the target station by dialing
the identification (ID) code preset for the forwarding station.
CALL FORWARDING - ALL CALLS
CALL FORWARDING - BUSY LINE
CALL FORWARDING - DON'T ANSWER
SPLIT CALL FORWARDING
These forwarding features can also be set/cancelled from an outside station via C.O./Tie line.
Operating Procedure
To set the ID code of the forwarding station
1.
Lift the handset; receive dial tone.
2.
Dial the access code for setting ID code; receive special dial tone.
3.
Dial the desired ID code (A maximum of 10 digits. The last digit must be "#"); receive service set tone.
To set Remote Call Forwarding Control from the target station
1.
Lift the handset; receive dial tone.
2.
Dial the Remote Call Forwarding Control access code; receive ring back tone. About six seconds after,
receive special dial tone.
3.
Dial the forwarding station ID code; receive special dial tone.
4.
Dial the forwarding station number; receive dial tone.
5.
Dial the access code or press the feature key for setting the desired forwarding feature; receive special dial
tone.
6.
Dial the target station number (A maximum of 12 digits); receive service set tone.
To cancel Remote Call Forwarding Control from the forwarding station
1.
Lift the handset; receive dial tone.
2.
Dial the cancel code or press the feature key for canceling the forwarding feature; receive service set tone.
To cancel Remote Call Forwarding Control from the target station
This procedure can also be applied when cancelling the forwarding feature which has set at the forwarding station.
1.
Lift the handset; receive dial tone.
2.
Dial the Remote Call Forwarding Control access code; receive ring back tone. About six seconds after,
receive special dial tone.
3.
Dial the forwarding station ID code; receive special dial tone.
4.
Dial the forwarding station number; receive dial tone.
5.
Dial the cancel code or press the feature key for canceling the forwarding feature; receive service set tone.
Service Conditions
1.
ID code entry is restricted when the button "#" is not pressed as the last digit.
2.
When setting a new ID code, the previous ID code is automatically erased.
3.
The list of ID codes cannot be output.
4.
ID code data is saved by the MAT command or the routine diagnosis program for saving Call Forwarding
data.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Remote Call Forwarding Control
Remote Call Forwarding Control
[C-5]
[C-2]
[C-3]
[S-99]
R-54
Page 637
Advertisement
Table of Contents
