Table of Contents
Advertisement
Service Conditions (cont'd)
12.
The Display patterns are shown below:
Display Pattern 1 (System Data 1, Index 390, b0=0, b1=0)
Display Pattern 2 (System Data 1, Index 390, b0=0, b1=1)
Display Pattern 3 (System Data 1, Index 390, b0=1, b1=0)
Display Pattern 4 (System Data 1, Index 390, b0=1, b1=1)
13.
Characters of 8-bit ASCII can be displayed for this feature.
14.
When the feature key which assigned FKY = 113 via AKYD is pressed, the display pattern on the LCD
(assigned by the ASYD command) changes according to the following conditions:
•
When My Line is Prime Line, Call ID Change Display Key is effective while terminating or in
conversation.
•
When My Line is not Prime Line, Call ID Change Display Key is effective while in conversation.
However, display pattern returns to the original setting when answering, holding, or transferring the call.
15.
When the received numbers of a calling number and characters of the assigned name exceed the display
field, whether to put them close to the right or left may be chosen by system data. At this time an asterisk
(*) is indicated on the exceeded digit position.
16.
The displayed number and characters flash when a call terminates and lights steadily during conversation.
17.
To display the Caller ID information on the D
following hardware is required.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Calling Party Number - Name Assignment and Display
24-digit Assigned name
24-digit Assigned name
24-digit Calling Number
24-digit Calling Number
CIRCUIT CARD NAME
16ELCH
16ELCJ
PA-DAIA
8-digit Calling
Number
Type of Call,
Sub-address
8-digit Assigned
Name
Type of Call,
Sub-address
term
to which the called line is assigned as a sub line, the
REMARKS
Page 259
C-157
Advertisement
Table of Contents
