Table of Contents
Advertisement
S-23
General Description
This feature allows a user to share a set of common Speed Calling numbers with other users in the group.
Operating Procedure
To record
1.
Lift handset or press SPEAKER key; receive dial tone.
2.
Dial the SPEED CALLING access code (one to three digits).
3.
Dial the abbreviated call code (one to three digits) and the called exchange network numbers; receive
service set tone.
Note:
If one digit code is used, the format must be 00 to 99.
To operate
1.
Lift handset; receive dial tone.
2.
Dial the SPEED CALLING feature access code.
3.
Dial the abbreviated call code (one or two digits).
4.
Call is completed.
term
To operate from a D
1.
Press the REDIAL key; receive dial tone. The LCD displays:
2.
Press the desired call code; the call is completed.
Service Conditions
1.
A maximum of 100 memory blocks per Module Group can be equipped for SPEED CALLING-GROUP.
A maximum of ten Speed Calling numbers per memory block can be assigned. This allows for a total of
1,000 numbers per Module Group.
2.
A Primary station will be assigned memory blocks, and associate stations in that group are assigned as
Secondary stations. The Primary station will have the capability to program 10 memory blocks commonly
used as Speed Calling numbers for that group; therefore, a group can consist of 100 Speed Calling numbers
maximum.
3.
Each abbreviated call code can store a maximum of 24 digits, including access codes and pauses. A
maximum of 18 digits can be stored, including access codes and pauses.
4.
A station can be assigned as a Primary station for only one group.
5.
There is no limit to the number of Secondary stations that may be assigned to one group.
6.
Secondary stations and their associated Primary station must belong to the same Module Group.
7.
A Secondary station can only be assigned to one Primary group.
8.
TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may not
be applied to Speed Calling, as desired.
9.
LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via Speed Calling access.
10.
SPEED CALLING-GROUP and SPEED CALLING-STATION [S-21] use the same block of memory
tables.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Speed Calling - Group
Speed Calling - Group
Note
LNR [*] / SPEED [_ _]
(Time Display)
S-23
Page 697
Advertisement
Table of Contents
