Table of Contents
Advertisement
M-48
Service Conditions (cont'd)
8.
When the system encounters a busy trunk in an attempt to make a dubbing of the message to the remaining
trunks, the trunk is retried after a 16 second interval. Each trunk is attempted a maximum of 16 times. If
the final attempt is rejected because of busy, no further dubbing attempts will be made.
EXECUTION
OF DUBBING
9.
Only the portion in which a message has been recorded is played back.
10.
The dubbing time is calculated by the following equation: (Dubbing Time) = (Recording time + 2 sec) x
(Number of Trunk). Refer to the following table to obtain the approximate time for dubbing:
DUBBING TIME
6 seconds
16 seconds
30 seconds
46 seconds
60 seconds
11.
This feature is not available to access a 4-DAT trunk through FCCS link.
Programming
STEP 1:
ANPD - Assign Number of Necessary Digits (NND) for the 1st digit of the access code of MULTI
CHANNEL RECORDING.
STEP 2:
ASPA - Assign access codes for the following Service Code Appendix (SSCA).
SRV
SIDA
SSCA 66 (= MULTI CHANNEL RECORDING <REC>)
68 (= MULTI CHANNEL RECORDING <RPY>)
STEP 3:
ASFC - For this feature, Service Feature Restriction data must be entered on a Service Feature Class
(SFC) basis.
SFI
87 (= MULTI CHANNEL RECORDING <REC>)
90 (= MULTI CHANNEL RECORDING <REPLAY>)
STEP 4:
ARTD - Assign Route Class Data for an announcement trunk.
STEP 5:
ATRK - Assign the announcement trunk data.
STEP 6:
MBTK - Assign the Make Idle status to the announcement trunk.
Page 530
Multi Channel Recording - DAT
16
sec
(BUSY)
(BUSY)
RETRY #1
RETRY #2
1
8
18
32
48
62
16
sec
(BUSY)
(BUSY)
NUMBER OF TRUNK
10
15
80
120
180
270
320
480
480
720
620
930
16
sec
TIME
(BUSY)
RETRY #16
20
63
160
504
360
1134
640
2016
960
3024
1240
3906
NEAX2400 IPX Feature Programming Manual
1
8n
18 x 1
32 x 1
48 x 1
62 x 1
NDA-24297, Issue 1
Advertisement
Table of Contents
