Table of Contents
Advertisement
T-9
Programming (cont'd)
TGBL data can be collected/transmitted from/to all LMGs by the circuit card DLMX (PA-PC94) via
DLKC circuit cards in the IPX-U. For more detailed information, see the NEAX2400 IPX Office Data
Specification and the NEAX2400 IPX Circuit Card Manual.
For the DLMX (PA-PC94) Circuit Card
STEP 1:
ASYD - SYS1 Index 15, b0-3: In hexadecimal, assign how many TGBLs are to be used out of a total
of 10 lamps available (on the Attendant Console).
Assign 01 (Hex) - 0A (Hex) for 1-10 busy lamps.
STEP 2:
ASYDL - SYS1 Index 804, b1.
0:
1:
SYS1 Index 946:
STEP 3:
ATRK - Assign the trunk data of DLMX.
RT:
LENS:
STEP 4:
ATGL/ATGLL - Assign the Attendant No., TGBL No. (1-10) and associated Route No. Note that
ATGL is used when ASYDL SYS1 Index 804 b1 = 0, and ATGLL when the same data = 1.
ATN:
TGN:
RT:
LGRT:
When the data of ASYD, SYS1 Index 804 b1 is changed, be sure to reassign ATGL/ATGLL command data.
Note 1:
Note 2:
When the system is an IPX-U, be sure that the following data has been assigned before entering the ATGL/
ATGLL command data:
ASYDL, SYS1 Index 640 (FPC of the node which has Attendant Consoles)
STEP 3:
MBTK - Assign the Make Idle status to the trunk assigned in Step 3.
Page 760
Trunk Group Busy Lamp
TGBL information based on External Route data (ATGL command)
TGBL information based on Logical Route data (ATGLL command)
FPC of the LN where DLMX card is mounted (for IPX-U).
LP PBI No. of the LMG where DLMX card is mounted (for IPX-UMG).
938 (DLMX)
Assign LV7 of odd-number Group (G)
Attendant No. (1-30)
Trunk Group No. (1-10)
External Route No. (1-255: for ATGL command)
Logical Route No. (1-899: for ATGLL command)
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
