NEC NEAX2400 IPX Programming Manual page 837

Feature programming manual
Hide thumbs Also See for NEAX2400 IPX:
Table of Contents

Advertisement

V-3D
V-3D
General Description
This feature is used for controlling the volume of a D
Operating Procedure
term
1.
The D
set is equipped with a sliding volume control knob located in the front, beneath the dial pad.
Volume can be increased by moving the control to the right, and decreased by moving it to the left.
2.
The ringing volume is controlled by a switch on the underside of the D
directly below the LCD Display Panel. The ringing volume is increased by moving the switch to the right
and decreased by moving the switch to the left.
3.
The ringing tone can be set to one of three distinct tones, using switch settings "1", "2", or "3", depending
on user preference. Each switch setting produces a separate distinct ringing tone.
Setting "1" produces the lowest.
Setting "2" produces a medium.
Setting "3" produces the highest.
To control the ringing tone, there is a switch located underneath the D
and is labeled RINGING TONE. It has switch settings marked 1, 2 and 3.
term
For D
Series E
term
1.
The D
is equipped with two control buttons located on the top front of the phone. Volume can be
increased by pushing the right control button while off-hook. Volume can be decreased by pushing the left
control button while off-hook.
2.
The ringing volume is also adjusted by the same two control buttons. Ringing volume by pushing the right
control button while the D
term
while the D
3.
The ringing tone can be set to one of four distinct ringing tones by performing the following: Press the
feature key + 3. Each time this is performed, one of the four patterns is selected.
Service Conditions
Ringing, Recall Ringing, and Voice Call Signal Tone are not controlled by VOLUME CONTROL.
Programming
No programming is required.
Page 794
Volume Control - D
Volume Control - D
term
is ringing. Decrease the ringing volume by pushing the left control button
is ringing.
term
term
set's built-in speaker and receiver.
term
term
. It is marked RING and located
term
. It is opposite the Transfer Key,
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1

Advertisement

Table of Contents
loading

Table of Contents