Table of Contents
Advertisement
Service Conditions (cont'd)
2.
DAY/NIGHT mode changeover will be performed in one-minute increments. If consistency between the
DAY/NIGHT mode at the Main and Satellite Nodes is lost, the status is restored to that of the Main Node
within 16 minutes.
3.
At the Main Node, from 1 to 15 tenants can use the system.
4.
At a Satellite Node, only TN = 1 is possible.
5.
When a Satellite Node is equipped with DAY/NIGHT mode changeover features, changeover of the
Satellite Node DAY/NIGHT mode is not performed from the Main Node.
6.
The Satellite Node cannot have an Attendant Console programmed.
7.
Selecting DAY/NIGHT option from the NEAX2400 IPX does not change the NEAX2000 IVS
NIGHT status.
Programming
STEP 1:
ASYD - System Data 1, Index 18, Bit 6: Day/Night change of Satellite Node (for Main Node only).
Assign data "1" at the Main Node.
System Data 1, Index 18, Bit 7: Day/Night change is executed by the Main Node (for Satellite Node
only). Assign data "1" at the Satellite Node whose Day/Night mode is to be changed in accordance
with key operation at the Main Node.
System Data 1, Index 19, Bits 0-3. Tenant Number (TN1-15) of the Main Node to which the Satellite
Node belongs (for Satellite Node only).
System 1, Index 75, Bit 0: Route Restriction Pattern (ARSC). Bit 1: Service Feature Restriction Pattern
(ASFC).
System Data 1, Index 75. Assign 1 (Day/Night Data) to Bit 0 (Route Restriction Pattern (ARSC)), Bit
1 (Service Feature Restriction Pattern (ASFC)), Bit 2 (Tenant Restriction Pattern (ATNR)), Bit 3 (Toll
Restriction Pattern (ATDP), and Bit 4 Class Restriction Pattern (AEFR).
System Data 1, Index 229 = 09 (for Main and Satellite Nodes).
STEP 2:
ARDN - Assign Point Code of Satellite Node (Index = 0-15, PC = 1-16367). (Main Node only.)
STEP 3:
ARSC - Assign data on Day/Night Mode basis.
STEP 4:
ASFC - Assign data on Day/Night Mode basis.
STEP 5:
ATDP - Assign data on Day/Night Mode basis.
STEP 6:
ATNR - Assign data on Day/Night Mode basis.
STEP 7:
AEFR - Assign data on Day/Night Mode basis (EPN Version).
To list up Day/Night information, use the LDNI command.
Note:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Centralized Day/Night Mode Change - CCIS
C-56
2
DAY/
Page 867
Advertisement
Table of Contents
