Table of Contents
Advertisement
M-20D
M-20D
General Description
This feature allows for the appearance of multiple lines on the programmable line/feature keys of the D
Operating Procedure
No manual operation is required.
Service Conditions
1.
Three kinds of lines can appear on D
MY Line (ML):
Prime Line (PL):
Sub Line (SL):
2.
If a feature is activated that can trigger an AUTOMATIC RECALL [A-8], only the station being recalled
will ring, and the associated line lamp will rapid wink. Other D
3.
All sublines of a D
4.
A virtual line (Software Line Appearance [S-33]), single line telephone or D
subline.
5.
CALL BACK - D
the My-Line of a D
Interactions
1.
Sublines can belong to another station, or be a virtual/software line appearance. Sublines will operate
under the restrictions of the MY Line. Sublines must be located within the same Module Group as the MY
Line when assigning ASYD, System Data 1, Index 321, bit 0 as "0."
2.
Multi Line service in the Inter-Module Group under the control of one LP is available when assigning
ASYD, System DATA 321, bit 0 as "1."
Programming
STEP 1:
ASDT - A LEN equipped with a D
Telephone Equipment Class (TEC) of 12.
STEP 2:
AKYD - Assign a MY Line, a Prime Line, and various sublines to the D
TN:
STN:
TP:
RING: Assign ringing to the entire phone
PL TN STN: Prime Line Tenant and Station Number
Page 486
Multiple Line Operation - D
Multiple Line Operation - D
term
This line is associated with the extension number assigned to the port on the
interface circuit.
This line is given priority for outgoing and incoming calls. The prime line is
automatically seized when going off-hook.
This line designates any other line appearing on a D
serve as a prime line, unless differentiated in system data programming).
term
must be located in the same Module Group as the D
term
- [C-1D] and OUTGOING TRUNK QUEUING - D
term
.
1
Station Number
term
Type of D
0/1:
0: No Ringing
1: Ringing All Lines
2: Ringing on Prime Line Only
3: Flexible Ring Assignment enables RG parameter
term
s:
term
term
Circuit Board must be assigned a station number and a
term
term
. (The MY Line will
stations will display that line as busy.
term
MY Line.
term
can be assigned to the
term
- [O-2D] are available from
term
s.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
term
set.
Advertisement
Table of Contents
