Table of Contents
Advertisement
C-15
Programming (cont'd)
TEC:
Telephone Class (1-31)
1:
2:
3:
12:
13:
14:
15:
16:
18:
23:
27:
RSC:
Route Restriction Class (0-15). For assignment of RSC, ARSC command.
SFC:
Service Feature Class (0-15). For assignment of SFC, ASFC command.
STEP 3:
ASCL - This command may be used to change the CLASS OF SERVICE - INDIVIDUAL for existing
stations. The RSC, SFC, and TEC may all be changed.
Service Feature Class
STEP 1:
ASFC - A possible 16 (0-15) different SFCs may be constructed allowing or denying access to the
various features.
Route Restriction Class
STEP 1:
ASYD - System Data 2, Index 1, Bits 4 & 5. Should a restricted station be routed to the Attendant
Console or receive reorder tone? Reorder tone: Bit 4 = 0, Bit 5 = 0. ATTENDANT CONSOLE: Bit
4=1, Bit 5=0.
STEP 2:
ARSC - A possible 16 (0* - 15) different Route Restriction Classes may be constructed, either
allowing a call or subjecting the call to TOLL DENIAL/DIVERSION [T-7] or TOLL RESTRICTION
- 3/6 DIGIT [T-7].
STEP 3:
ATDP - Assignment of Toll Distinctive Pattern command is assigned when Toll Restriction is
required. When Toll Restriction changes from Day to Night, then ATDP must be assigned for both
Day mode and Night mode.
* RSC 0 is reserved for Attendant Console use only.
Note:
If a restricted station is routed to the ATT, all RRI 3 must be RES = 2.
Page 180
Class Of Service - Individual
DP (10pps)
PB
DP/PB
term
D
term
Data terminal via D
Hotline
CAS Line
Data terminal via Data Module
Virtual Circuit
ISDN Terminal
Eight Conference Equipment
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
