Table of Contents
Advertisement
C-73
General Description
This feature allows a station to which CALL BACK [C-1] has been set to initiate another call, within a
predetermined time period after becoming idle and before the CALL BACK [C-1] feature is activated.
Operating Procedure
No manual operation is required.
Service Conditions
1.
This feature is assigned in system programming, on a system-wide basis.
2.
The CALL BACK-DELAYED timer can be set in multiples of 2 seconds, to a maximum of 14 seconds.
Programming
ASYD - System Data 1, Index 5, Bits 4, 5, and 6 = timer; Bit 7 = Out of Service / In Service (No/Yes).
Timer as default is set at 00 = 2 seconds. Maximum delay is 14 seconds.
System Data 1, Index 139. No Answer Timer for CALL BACK. Assign 00H. (RAM data is 3FH = 30
seconds.)
System Data 2, Index 0, Bit 0. Is CALL BACK enabled on a per-tenant basis? 0/1: No/Yes.
System Data 2, Index 4, Bit 0. CALL BACK and TRUNK QUEUING access code are same or
separate? 0/1: Separate / Same.
System Data 3, Index 3, Bit 5. Enable Ringer pattern 5 for CALL BACK. See DISTINCTIVE
RINGING [D-10].
System Data 3, Index 7. Assign data 42H for four seconds ON, two seconds OFF.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
ASYDN - These data must be assigned to the NCN.
System Data 1, Index 5, b4~b6, Call Back Delayed Timer.
System Data 1, Index 5, b7, 0/1= Call Back Delayed Timer is out of service/in service.
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Back - Delayed
Call Back - Delayed
Note
C-73
Page 229
Advertisement
Table of Contents
