Table of Contents
Advertisement
Service Conditions (cont'd)
15.
A PA-CS33 circuit card is required. The switch setting for PA-CS33 (ATI) is shown below:
16.
The Attendant Console must be accommodated in one LN only when used in the IPX-U system.
17.
A terminating node (FPC) must be assigned in the FCCS network.
18.
Identical system data related to Attendant Console should be programmed at all nodes.
19.
A different destination for C.O. incoming call (ring down) cannot be set at each tenant group.
Interactions
There are no known interactions.
Programming
Called numbers display when Call Forwarding to ATTCON.
ASYD - System Data 1, Index 70, Bit 0 (0/1=out of service/in service)
Call Waiting lamp display.
System Data 2, Index 8 and 9, Bit 0-7.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - This data must be set to all the nodes.
System Data 1, Index 640: Assign the Fusion Point Code (FPC) of the node providing the Attendant
Console.
Note 2
STEP 2:
ASPAL - This data must be set to all the nodes.
Assign SRV=SSC, SID=2 (Operator Call), FPC of the node that operator calls are to be terminated to.
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note 1:
in addition to ASYDL or ASYDN.
Assign the self FPC at the terminating node.
Note 2:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Attendant Console
SWITCH NAME
SW16
Note 1
1
2
A-3
SETTING
OFF (fixed)
ON (fixed)
Page 7
Advertisement
Table of Contents
