Table of Contents
Advertisement
D-87
Service Conditions (cont'd)
c.) Intercom Bridge
Original
Station
Addt.
Station
After 5 seconds
Three
Station
d.) Intercom Bridge Restriction
17.
To answer a call terminated to the INTERCOM line while the Prime Line is busy, press an INTERCOM
line key.
18.
The DIAL INTERCOM ringing by an incoming call is interrupted while the MANUAL SIGNALING [M-
47] signal is being sent out.
19.
While a call is in progress on a multi-line, the AUTOMATIC INTERCOM line, or MANUAL
INTERCOM line, pressing the DICM key can disconnect the call to allow a DIAL INTERCOM call
origination or answer.
20.
FCCS link is not available for this feature.
Programming
STEP 1:
ASYD - System Data 1, Index 59, Bit 7. Is AUTOMATIC/MANUAL and DIAL INTERCOM in
service? 0/1: No/Yes.
System Data 1, Index 69, Bit 6. Is a Warning Tone required when creating a three-way AUTOMATIC/
MANUAL INTERCOM call? 0/1: No/Yes.
System Data 1, Index 78, Bits 0 & 1. Assign both Bits as data "1" to enable full D
operation.
System Data 3, Index 3. Assign data 20H for burst ringing if necessary.
System Data 3, Index 7. Assign the Ringing Pattern if necessary.
Page 304
Dial Intercom Number of the Additional Station
OVERRIDE
Dial Intercom Number of the Calling Station (1 or 2 digits)
OVERRIDE
CONF
* CONF lamp goes on
CONF REST
* When the DICM key is pressed for the bridge, after
originating a call, the above is displayed for 5 seconds.
Dial Intercom
(Time Display)
(Time Display)
(Time Display)
(Time Display)
XX
XX
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
term
display
Advertisement
Table of Contents
