FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ARTDN - Assign the route data of the trunk for AUTOMATED ATTENDANT.
RT:1
1-OSGS
Assign the route data of the Digital Announcement Trunk.
STEP 2:
AAEDN - Assign the Announcement Equipment for AUTOMATED ATTENDANT.
Announcement Equipment for sending the first announcement.
(EQP = 34, C = 0, R = 1, A = 1, M = 0)
Announcement Equipment for sending the second announcement
(EQP = 35, C = 0, R = 1, A = 1, M = _)
STEP 3:
ARRCN - Cancel the restrictions on the trunk route for AUTOMATED ATTENDANT and the route
for the Digital Announcement Trunk.
ICRT: (Trunk route for AUTOMATED ATTENDANT)
OGRT: (Route for Digital Announcement Trunk)
ARI-D-RES
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Automated Attendant
Note
:2
4-INSG
:2 or 7
6-TCL:4
A-82
Page 61