Table of Contents
Advertisement
Service Conditions (cont'd)
10.
To initiate CALL WAITING - ORIGINATING [C-31] with GROUP CALLING, a D
a.) Dial the CALL WAITING - ORIGINATING [C-31] access code.
b.) Dial the GROUP CALLING access code (maximum 3 digits).
c.) Dial the GROUP CALLING station code (1 or 2 digits).
d.) CALL WAITING-ORIGINATING access code is not needed if automatic is set.
Interactions
1.
As an example of a GROUP CALLING application, the following conditions exist:
System Station Numbering: 5XXXX and 6XXX
Speed Calling Access: 3 (Assigned in ASPA)
100 Groups of ten stations
GROUP CALLING Station Numbering consists of the following: 30-39
2.
Station in GROUP CALLING dial only two digits to reach other members of the group.
3.
All normal STATION-TO-STATION CALLING [S-11] capabilities and restrictions apply, such as
VOICE CALL-D
4.
GROUP CALLING applies to the MY-Line of the D
Programming
STEP 1:
ANPD - Reserve a number level for feature access. Assign Connection Indexes, CI = N, H, B; Normal,
Hooking, and Busy (applicable to any feature assigned to this level). Assign NND in accordance with
a predetermined numbering plan.
STEP 2:
ASPA - Two access codes must be assigned for this feature.
Assign a Tenant and an Access Code (ACC) for assigning individual speed calling. For INDIVIDUAL
SPEED CALLING-ENTRY, assign a Connection Index of Normal (N). For SRV = SSC (Service
Code), assign SID 14. For INDIVIDUAL SPEED CALLING-ACCESS, assign a tenant and an access
code (ACC). Assign Connection Index of Normal (N). For SRV = SSC (Service Code), assign SID 21.
STEP 3:
ASFC - Assign a Service Feature Class that allows SFI 19 to the stations allowed SPEED CALLING-
STATION [S-21].
STEP 4:
AISA - Program the tenant, station, type of station, and the number of SPEED CALLING blocks to be
assigned to the Source station. One station of each GROUP CALLING group is assigned as the
Source. The Source then assigns all the stations and virtual numbers as abbreviated codes.
TN:
STN:
MST/SLV: Source/Secondary
BLOCK:
STN:
STEP 5:
AKYD - Assign the virtual circuit to a D
station number of the virtual circuit. This key will be the GROUP CALLING key.
STEP 6:
AISD - can also be used to assign INDIVIDUAL SPEED CALLING data.
FCCS Programming
No unique programming is required for the FCCS network.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
term
[V-2D], MESSAGE REMINDER-D
Tenant Number
Station Number
M: Primary Station
S: Secondary Station
Number of Blocks
When assigning the Secondary station, assign the Primary station number.
Group Calling
term
[M-19D], CALL BACK [C-1], etc.
term
.
term
key. Assign KYI = 2, multi-line key, and assign the
G-2
term
must:
Page 377
Advertisement
Table of Contents
