Table of Contents
Advertisement
M-25
Programming (cont'd)
STEP 6:
ADSL - Assign SN=1 (Originating; DT Connection) and FKY=22 (Call Forwarding - Don't Answer;
FDN).
This command is used for assigning the function to a soft key.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDN - These data must be set to the NCN.
System Data 1 Index 69, b7. Enable Multiple Call Forwarding-Busy Line/Don't Answer/All Calls. 0/
1=Out of Service/In Service
Note:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
Page 502
Multiple Call Forwarding - Don't Answer
Note
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
