Programming (cont'd)
STEP 8:
ACFO - For tenant-wide CALL FORWARDING-DON'T ANSWER-D
destination (CFI) of either the Attendant Console or a station.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - This data must be assigned to the node set Call Forwarding service.
System Data 1, Index 640: Assign the Fusion Point Code (FPC) of the node providing the attendant
console.
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
The data of the ASFC command is assigned to the node set Call Forwarding service.
Note 2:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - Don't Answer - D
Note 1
term
term
, assign CF = 2 for a
C-3D
Page 129