Table of Contents
Advertisement
D-31
Programming (cont'd)
CNT:
RT:
TK:
The Tenant and Station parameters will be prompted only if ASYD calls for separate announcements
for UCD groups.
The Delay timer, DLYT, is the time that the Delay Announcement trunk will ring and collect other
incoming calls that will listen to the DELAY ANNOUNCEMENT-UCD.
The Message timer, MSGT, should include both the DELAY ANNOUNCEMENT-UCD time plus
idle time before and after the announcement. The following patterns are available.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDN - This data must be assigned to the NCN. System Data 1, Index 70, b6: 0/1= DAT is common
for all the UCD groups/DAT is different per UCD group
STEP 2:
AUADN - These data must be assigned to the NCN.
UGN:
TELN:
DLYT:
MSGT:
RP:
INT:
CNT:
RT:
TK:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note 1:
in addition to ASYDL or ASYDN.
The current data should also be set in addition the above-mentioned command. The command to be set to
Note 2:
the node that accommodates the UCD controlling station only: ATRK, MBTK
Page 298
Delay Announcement - UCD
Number of Announcement Trunks
Route Number
Trunk Number
seconds
Delay Timer
6
Delay Timer
Idle Time
6
Delay Timer
Idle Time
6
Delay Timer
Idle Time
Note 1
User Group Number
Telephone Number
Delay Timer (0-30 sec; 2-second increment)
Message Timer (0-30 sec; 2-second increment)
Announcement Replay
0/1=Only one/Replay
Replay Interval (0-30 sec; 2-second increment)
Number of Announcement Trunks
Route number
Trunk number
16
4
6
Actual
Idle Time
Message
12
Actual Message
12
Actual Message
24
6
Idle Time
6
Idle Time
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
32
Advertisement
Table of Contents
