Table of Contents
Advertisement
S-3
S-3
General Description
This feature allows a user or ATTENDANT CONSOLE [A-3] to call frequently dialed numbers using fewer digits
(abbreviated call codes) than would normally be required.
Operating Procedure
1.
Lift handset; receive dial tone,
2.
Dial SPEED CALLING - SYSTEM access code (maximum three digits), or press D
key.
3.
Dial abbreviated call code (maximum four digits).
4.
Call is completed.
Service Conditions
1.
SPEED CALLING - SYSTEM codes programmed into system data are accessible by all stations with a
CLASS OF SERVICE - INDIVIDUAL [C-15] permitting SPEED CALLING - SYSTEM.
2.
Each abbreviated call code can store a maximum of 24 digits, including access codes and pauses.
3.
SPEED CALLING - SYSTEM numbers are programmed via system data entry from the
MAINTENANCE ADMINISTRATION TERMINAL (MAT) [M-18].
4.
Stations may be denied access to SPEED CALLING - SYSTEM via CLASS OF SERVICE [C-15]
assignment in system data. SPEED CALLING may also be allowed or denied on either a station or tenant-
wide basis.
5.
TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may not
be applied to SPEED CALLING - SYSTEM, as desired.
6.
LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via SPEED CALLING - SYSTEM access.
7.
If the station is restricted from dialing outside via programming, the station can still access SPEED
CALLING - SYSTEM.
8.
A maximum of 1,000 codes can be assigned per NEAX2400 IPX system.
9.
The outgoing call using a trunk in the remote node is applied to this feature.
Interactions
1.
FORCED ACCOUNT CODES [F-7] and AUTHORIZATION CODES [A-20] cannot be programmed for
use via the SPEED CALLING-SYSTEM.
2.
Pauses are programmable from the MAT using the "P" key of the keyboard. Pauses consume one digit of
the available 24 digits. A pause lasts for 2.8 seconds. A pause cannot be added directly after an LCR access
code.
3.
TOLL DIVERSION/TOLL DENIAL [T-6] and TOLL RESTRICTION 3/6 DIGIT [T-7] will interact with
this feature if SPEED CALLING-SYSTEM is toll restricted.
4.
Special dial tone may be returned after dialing SPEED CALLING-SYSTEM if AUTHORIZATION
CODES [A-20] are operational in the system and Toll Restriction applies to SPEED CALLING-
SYSTEM.
5.
See SPEED CALLING OVERRIDE-SYSTEM [S-61].
Page 642
Speed Calling - System
Speed Calling - System
term
Speed Calling
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
