Table of Contents
Advertisement
M-1
M-1
General Description
This feature allows a user dial access to paging equipment, and connects both parties automatically, after the called
party has answered the page.
Operating Procedure
To page
1.
Calling station dials the Paging access code; receives continuous ringback tone for 1 second.
2.
Calling station pages the desired party.
3.
Calling station remains off-hook or hangs up.
To answer
1.
Called party dials the Page answer code.
2.
NON-DELAY OPERATION
a.) The party paged is immediately connected to the calling party.
3.
DELAY OPERATION
a.) The party paged receives ringback tone.
b.) The calling station rings.
c.) The calling station goes off-hook and is immediately connected to the paged station.
Service Conditions
1.
A maximum of six routes can be provided with paging trunks.
2.
Paging equipment is customer provided.
3.
One paging trunk will be assigned to each route.
4.
Paging access and answer codes are assigned in system data programming to correspond with each route.
5.
The maximum number of digits that can be used as a paging access and/or answer code is 3.
6.
The type of paging service provided on a system basis is programmed via the MAINTENANCE
ADMINISTRATION TERMINAL [M-18] into the system database.
7.
A page waiting to be answered is automatically cancelled after a predetermined program duration. See
VARIABLE TIMING PARAMETER
8.
Central Office Trunks (COTs) are used as interface circuits to the paging equipment.
9.
Loop signaling is the recommended signaling type. Refer to PAGING TRANSFER [P-10].
Interactions
1.
MEET-ME PAGING and PAGING ACCESS [P-1] can be provided simultaneously in the same system.
In ARTD, CDN 6:TCL must be assigned as data "8" for MEET-ME PAGE, while PAGING ACCESS [P-
1] routes may be assigned as data "11", General Page, or as data "1", DDD. Separate access codes for each
feature are required. A MEET-ME PAGING answer and cancel code is required for each MEET-ME
PAGING zone.
2.
MEET-ME PAGING is limited to stations and Attendant Consoles. CO trunks, TIE LINE ACCESS [T-
3], or REMOTE ACCESS TO PBX SYSTEM [R-2] calls must have the Attendant Console or user
perform the paging operation.
3.
The Attendant Console cannot dial the MEET-ME PAGING answer codes.
Page 464
Meet-Me Paging
Meet-Me Paging
[V-1]
for other selectable timing choices.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
