Table of Contents
Advertisement
Service Conditions (cont'd)
d.) The maximum digits for each data are as follows:
e.) When the called station does not have the telephone number, the FPC/Telephone Number/UGN
data is output as "0".
f.) When the calling party is the station which does not have the telephone number, the Tenant
Number/FPC/Telephone Number/UGN data is output as "0". The kind of call is output as "10".
g.) If the number of the trunk call (Caller ID) cannot be identified, the Trunk Call Number data is
output as "0". The kind of call is displayed as "20".
7.
When the call is terminated via the No. 7 CCIS, the obtainable calling party numbers are:
•
Maximum 8 digits (when CI (route data) = 0)
•
Maximum 16 digits (when CI (route data) = 1)
System message is output at the node that the called station (informer) belongs to.
8.
Unless the message output is set on a network basis, System Message [26-R] is created at the node which
contains the called station (informer).
9.
The default message output grade is shown below:
26-R
10.
To obtain the Caller ID via an analog trunk, be sure to use PA-8COTBJ. Other analog trunk cards cannot
provide this feature.
11.
This service is available with the Analog Caller ID Service.
Interactions
1.
When the service DUAL STATION CALL [D-156] is used, a call can be terminated to a Main Station and
a Sub Station simultaneously. At this time, the calling party information can be obtained only by the key
operation from the Main Station side. Information to be obtained from the Sub Station is about the last call
directly terminated to the Sub Station.
Programming
STEP 1:
ANPD/ANPDL/ANPDN - Assign 1st digit code (1st DC) and number of necessary digits (NND) for
feature access and cancel. CI = N (Normal).
STEP 2:
ASPA/ASPAL/ASPAN - Assign the access code for CALL TRACE, CI = N (Normal), SRV =
SSCA, SIDA = 116 (Output of System Message [26-R]).
STEP 3:
ASFC - Assign a Service Feature Class to allow CALL TRACE for the stations, SFI = 170, RES = 1
(Restriction: lifted).
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
DATA
FPC
Tenant Number
Station Number
UGN
Telephone Number
Trunk Call Number
MJ
—
Call Trace
MN
—
MAXIMUM DIGITS
3
3
6
3
16
32
SUP
GR
—
C-160
2
Page 263
Advertisement
Table of Contents
