Table of Contents
Advertisement
C-28
Operating Procedure (cont'd)
To cancel from a multi-line D
1.
Lift the handset or press the SPEAKER key; receive dial tone. Press the CALL FORWARDING - ALL
CALLS FORWARD feature key; receive service set tone. The LED of the associated feature key will go
out. The LCD displays:
2.
Replace the handset or press the SPEAKER key.
Service Conditions
1.
CALL FORWARDING - ALL CALLS - OUTSIDE may be set or cancelled by either a user or the
Attendant.
2.
Stations may be assigned this feature via CLASS OF SERVICE - INDIVIDUAL [C-15] programming in
system data.
3.
For CALL FORWARDING - ALL CALLS - OUTSIDE, Speed Call List numbers may be programmed
as the destination telephone number. This permits the sent digits to exceed the 12-digit maximum.
4.
When using this feature, either the calling station or the forwarding station is recorded by SMDR [S-10]
as the originating station of calls forwarded. The selection between the above stations is decided by system
data.
term
5.
The calling D
as regular outgoing CO calls. The calling D
OUTSIDE appears as a STATION-TO-STATION CALLING - CCIS [S-57] call.
6.
CALL FORWARDING - ALL CALLS - OUTSIDE can be restricted by the Trunk Route Restriction Class
(RSC) of the originating station.
7.
There is no limit to the number of stations that may activate this feature simultaneously.
8.
Restrictions for outgoing connection by CALL FORWARDING - ALL CALLS - OUTSIDE are as
follows:
a.) When originating a call from a station: RSC is verified when this service is in effect.
b.) When originating a call from a trunk: Restriction for tandem connections between the incoming
trunk and the outgoing trunk is selected for the call where CALL FORWARDING - ALL CALLS
service occurs.
9.
When a caller places a call via Outgoing Call Alternative (OGCA) and when the first outgoing route and
the calling party are restricted, this service cannot be set. In this case, the service can be set via the
following procedure:
a.) assign a dummy route,
b.) clear the restriction between the dummy route and all the stations,
c.) assign the dummy route as the first route of OGCA.
10.
When a destination of CALL FORWARDING - ALL CALLS - OUTSIDE has already been assigned,
even if the feature is restricted by the new office data or changing of Day/Night mode, the assigned data
can still be used or cancelled.
11.
A maximum of 24 digits, including trunk access code, can be stored.
12.
This feature allows a call to terminate to a trunk outside of the FCCS network. Accordingly, the access
code + office code or the access code including office code is required before dialing the telephone number
to recognize the terminating node.
Page 204
Call Forwarding - All Calls - Outside
term
FORWARD CANCEL
(Time Display)
display for CALL FORWARDING - ALL CALLS and BUSY LINE - OUTSIDE appear
term
display for CALL FORWARDING - DON'T ANSWER -
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
