Table of Contents
Advertisement
Service Conditions (cont'd)
13.
When the incoming call is forwarding to the public network, be sure to add the outgoing access code +
destination area code or the outgoing access code including destination area code number before dialing
subscriber number.
14.
A call can be forwarded to a trunk in the remote node via FCCS link.
Interactions
1.
A 24-digit limitation exists in memory for CALL FORWARDING-OUTSIDE.
2.
CALL FORWARDING-OUTSIDE is an enhancement of the CALL FORWARDING-ALL CALLS [C-
5] feature.
3.
This feature may be set from the Attendant Console.
4.
A call may be CALL FORWARDED-OUTSIDE to a SPEED CALLING-SYSTEM [S-3] or SPEED
CALLING-STATION/GROUP [S-21, 23] number. This will allow a long-distance number that exceeds
12 digits.
5.
A user can verify that CALL FORWARDING-OUTSIDE has been properly activated and can inform the
designated outside party of the activation by dialing the forwarded station from any station in the system.
6.
If a station is restricted from outside calling, CALL FORWARDING-OUTSIDE will be denied. TOLL
RESTRICTION-3/6 DIGIT [T-7] will be applied to CALL FORWARDING-OUTSIDE via SPEED
CALLING-SYSTEM, STATION, GROUP [S-3, 21, 23], if tenant data assigned in System Data 2 applies
Toll Restriction to speed calling.
7.
Upon activation of this feature, STATION MESSAGE DETAIL RECORDING [S-10] will record the
outside exchange number whenever a call is forwarded.
8.
A station can use the OUTGOING TRUNK QUEUING [O-2] feature to queue an outgoing trunk and a
call that is being forwarded via the CALL FORWARDING-OUTSIDE feature. The call will be outpulsed
when a trunk becomes available.
9.
A station assigned to a STATION HUNTING [S-7, 8, 9] Group will be temporarily removed from the
Hunt Group if it initiates CALL FORWARDING-OUTSIDE.
10.
If a call using the CALL BACK [C-1] feature is placed from a station that has activated CALL
FORWARDING-OUTSIDE, the Call Back will ring at the forwarding station, not the outside station.
11.
When OUTGOING TRUNK QUEUING [O-2] (on-hook) is initiated by the forwarding station, the
ringback will be to the forwarding station and not to the outside station.
12.
A DIRECT-IN TERMINATION [D-7] call may be sent through CALL FORWARDING-OUTSIDE.
13.
The number of digits (maximum 12) that will be accepted before forwarding is set is determined by
AMND.
14.
This feature allows a call to terminate to a trunk outside of the FCCS network. Accordingly, "the access
code + office code" or "the access code including office code" is required before dialing a telephone
number to recognize the terminating node.
15.
When forwarding the incoming call to the public network, be sure to add "the outgoing access code +
destination area code" or "the outgoing access code including destination area code number" before
dialing a subscriber number.
Programming
STEP 1:
ASYD - System Data 1, Index 4, bit 6. One burst of ringing all CALL FORWARDING - ALL CALLS
[C-5] in service? 0/1: No/Yes. System Data 1, Index 20, bit 7. Calling or forwarded party show on
SMDR? 0/1: Calling/forwarded.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - All Calls - Outside
C-28
Page 205
Advertisement
Table of Contents
