Table of Contents
Advertisement
M-24
Interactions (cont'd)
5.
If an Attendant attempts BUSY VERIFICATION [B-3] to Station A, which has CALL FORWARDING-
BUSY LINE [C-2] set to Station B and Station B is busy, BUSY VERIFICATION [B-3] proceeds against
Station B. If Station A has set CALL FORWARDING-BUSY LINE [C-2] to the Attendant Console,
BUSY VERIFICATION [B-3] is allowed at Station A, if Station A is busy.
6.
When CALL FORWARDING-BUSY LINE [C-2] is in effect, the activating station may be used to
originate calls.
7.
When a station is call forwarded, the destination station is recorded by STATION MESSAGE DETAIL
RECORDING [S-10].
Programming
STEP 1:
ASYD - System Data 1, Index 5, Bit 0. Are the access codes for CALL FORWARDING-BUSY LINE
[C-2] and CALL FORWARDING-DON'T ANSWER [C-3] the same or separate? 0/1: Same/Separate.
System Data 1, Index 5, Bits 3, 2, & 1. Maximum number of MULTIPLE CALL FORWARDING-
ALL CALLS [M-44], -BUSY LINE [M-24] occurrences.)
BIT 3
0
0
0
0
1
1
1
1
System Data 1, Index 69, Bit 5. Station Hunting after CALL FORWARDING-BUSY LINE [C-2].
Data "0": Hunting takes place in forwarding station's group. Data "1": Hunting takes place in
destination station's group.
System Data 1, Index 69, Bit 7. MULTIPLE CALL FORWARDING-BUSY LINE, -ALL CALLS [M-
44], in service? 0/1: No/Yes.
System Data 2, Index 6, Bit 1. Enable CALL FORWARDING-BUSY LINE [C-2] on a per-tenant
basis.
STEP 2:
ANPD - Reserve a number level for feature access and cancel. Assign for Normal (N), Hooking (H),
and Busy (B). Assign NND in accordance with a predetermined numbering plan.
STEP 3:
ASPA - Assign an access code to CALL FORWARDING-BUSY LINE [C-2] entry, SID = 10 and to
CALL FORWARDING-BUSY LINE [C-2] cancel SID = 11. Assign a Connection Status Index (CI)
for Normal (N) service.
STEP 4:
ASFC - Assign a Service Feature Class that allows SFI = 9 to the stations that have CALL
FORWARDING-BUSY LINE [C-2].
STEP 5:
AKYD - For D
programmable line/feature key. Type:Function:CALL FORWARDING-BUSY LINE [1].
STEP 6:
ADSL - Assign SN=1 (Originating; DT Connection) and FKY=1 (Call Forwarding - Busy Line;
FDB).
This command is used for assigning the function to a soft key.
Page 496
Multiple Call Forwarding - Busy Line
BIT 2
0
0
1
1
0
0
1
1
term
sets, CALL FORWARDING-ALL CALLS [C-5D] may be assigned to a
BIT 1
MAXIMUM NUMBER OF JUMPS
0
1
0
1
0
1
0
1
NEAX2400 IPX Feature Programming Manual
1
1
2
3
4
5
5
5
NDA-24297, Issue 1
Advertisement
Table of Contents
