Table of Contents
Advertisement
Interactions (cont'd)
6.
When the system is in the night mode of operation, incoming FX calls can be answered using NIGHT
CONNECTION - FIXED [N-1], FLEXIBLE [N-2] or TRUNK ANSWER FROM ANY STATION [T-8]
feature.
7.
DIRECT INWARD DIALING [D-8] is not provided for FX trunks. All calls are normally routed to the
Attendant, UCD group, or a CAS Attendant.
8.
Outgoing FX trunk calls can be restricted from preselected stations by the assignment of one or more of
the following restrictions:
a.) Restriction from Outgoing Calls
b.) Miscellaneous Trunk Restrictions
c.) Toll Restriction
9.
FX CO Access: This service provides access to a distant CO via FX trunks. All incoming calls to the
system (from the FX, CO area) are placed to the listed FX directory number and are answered by the
Attendant in a similar way to Listed Directory Number (LDN) service. Outgoing calls are made on an
Attendant-handled basis or on a dial access basis by stations.
10.
A unique Attendant Console INCOMING CALL IDENTIFICATION (ICI) [I-2] may be displayed for
each local and FX LDN.
11.
A unique Attendant Console trunk group busy lamp may be assigned to indicate the busy/idle status for
an FX trunk group.
12.
The COT circuit packages are used to provide the trunk interface circuit.
13.
An FX route may be used with any other feature available to any other route, including the following:
DIRECT OUTWARD DIALING
REMOTE ACCESS TO SYSTEM
TRUNK-TO-TRUNK CONNECTION
TRUNK ANSWER FROM ANY STATION (TAS)
TOLL RESTRICTION-3/6 DIGIT
Programming
STEP 1:
ARTD - Assign the FX ACCESS route as shown below:
GROUND START:
RT: 1
1-OSGS
6-TCL
LOOP START:
RT: 31
1-OSGS
6-TCL
STEP 2:
ATRK - Assign the LENs, FX ACCESS Trunk Route Number, Trunk Number, and Tenant Number.
STEP 3:
MBTK - Assign the Make Idle Status to the FX access Trunks.
STEP 4:
ANPD - Reserve a number level for trunk access. Assign for Normal (N) and Hooking (H) service.
Number of Necessary Digits (NND) is usually 1 or 2. Busy Lamp Field is not activated.
STEP 5:
ASPA - Assign the access code to the FX route. The type of service is SRV = OGC (Outgoing Call),
Outgoing Trunk. Assign the route number associated with this access code.
STEP 6:
ARSC - The Route Restriction Class must be constructed in a manner to allow the station access to the
involved routes.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
:2
2-ONSG
:3
:2
7-L/T
:1
:2
2-ONSG
:3
:2
7-L/T
:1
FX Access
3-ISGS
:1
8-RLP
:2
3-ISGS
:1
8-RLP
:2
[D-9]
[R-2]
[T-10]
[T-8]
[T-7]
4-INSG
:3
5-TF
15-LSG
:1
4-INSG
:3
5-TF
F-2
:3
:3
Page 351
Advertisement
Table of Contents
