Table of Contents
Advertisement
E-20
Service Conditions (cont'd)
•
If OG call is from an ATTCON and Individual ATT Access Code is assigned, and also ANI
data is assigned:
KP-0-N**-****-ST
•
If OG call is from an ATTCON and Individual ATT Access Code is unassigned, and ANI data
is assigned:
KP-0-N**-****-ST
•
If OG call is from an ATTCON and ANI data is unassigned:
KP-1- ST
b.) Outgoing call from station/Attendant Console of Remote office, and call termination via CCIS of
Main office.
•
If OG call is from a station and ANI data is assigned:
KP-0-N**-****-ST
•
If OG call is from a station and ANI data is unassigned:
KP-2- ST
•
If OG call is from an Attendant Console and ANI data is assigned:
KP-0-N**-****-ST
•
If OG call is from an Attendant Console and ANI data is unassigned:
KP-1- ST
c.) Outgoing call from station/Attendant Console of Remote office, and call termination to a TIE
Line of Main office.
KP-2-ST
6.
An independent route is required for E911 interface.
7.
After caller's number is sent out to the remote office by E911-ANI, it takes some time until a speech path
is established.
8.
E911-ANI - CCIS service data are assigned only at Main office; no specific data are assigned at the remote
office.
9.
Both AUTOMATIC NUMBER IDENTIFICATION (ANI) [A-78] service and E911-ANI UNIFIED
NUMBER OF DIGITS [E-18] service must have been assigned.
10.
The Central Office Code (COC) consists of 1-5 digits. If office number and station number are used, the
maximum total number of digits is still 5. The Code is set in the ARNP command as RT0.
Example 1:
Office number: 82
Station number: 2xxx, 3xxx
Page 916
E911 - ANI Unified Number of Digits - CCIS
ANI sending number
Information digit
ANI sending number
Information digit
Information digit
ANI sending number
Information digit
Information digit
ANI sending number
Information digit
Information digit
Information digit
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
