Table of Contents
Advertisement
R-51
Service Conditions (cont'd)
•
8-digit display
ABCDEFGH: trunk type assigned
by this feature.
8.
This feature is available when the D
available when the user presses the held sub line after holding a call using the HOLD key.
9.
For data assignment to each of NDM (Network Data Memory) and LDM (Local Data Memory), different
commands can be used. However, the data in NDM has a priority. The logical route must be assigned to
NDM, and the physical route must be assigned to LDM.
Programming / FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - System Data 1, Index 512, FPC of the self-node.
System Data 1, Index 513, LDM usage.
System Data 1, Index 514, NDM usage.
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
This data is required for the FCCS network.
Note 2:
STEP 2:
ADRTN/ADRTL - Assign the Route Name data on a route basis.
LGRT/RT: Logical Route or Physical Route Number
TYPE:
DISP:
Note:
When the system is used within an FCCS network, assign the Logical Route Number via LGRT, ADRTN.
When the system is not used within an FCCS network, assign the Physical Route Number via RT, ADRTN.
ADRTN command data has priority over the ADRTL command data. Route Name data programmed by
ADRTN is displayed at all FCCS nodes in the network.
Page 636
Route Name Display
term
Note 1
A maximum digit for the Route Name data
1/2 = 4 digits / 8 digits
Displayed Data
user presses the call terminating sub line. This feature is also
Note 2
Note 2
Note 2
ABCDEFGH
Note 3
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
