Table of Contents
Advertisement
D-149
Programming (cont'd)
STEP 1:
Assign the DSS/BLF to an even-numbered LEN level. (In this example "LV 0" is used.)
TN:
X
STN:
200
LEN:
000100
TEC:
12
RSC:
X
SFC:
X
Assign a station which is used for programming DSS keys (KYNs 31-60) to the subsequent LENs. (In
this example "LV 1" is used.)
TN:
X
STN:
201
LEN:
000101
TEC:
12
RSC:
X
SFC:
X
STEP 2:
Assign key data for 60 DSS keys. The upper 30 DSS keys (KYNs 1-30) are assigned using the first
port ("LV 0" in this example) and the remaining lower 30 DSS keys (KYNs 31-60) are assigned using
the second port ("LV 1" in this example). Be sure to assign the associated D
Station Number of Prime Line.
TN:
X
STN:
200 or 201
TP:
1
RING: X
PRI:
0
LN PRE:0 (=Prime Line Pick up)
MWD: X
PL TN: X
STN:
400
S:
0 (=Off Hook Suppression is off)
KYN 1 must be programmed as the DSS/BLF station which has been assigned in ASDT.
KYN: 1
KYI:
2 (=Multi Line)
KD:
0 (=Line)
TN:
X
STN:
200 or 201
KYN 2 must be programmed as the associated D
KYN: 2
KYI:
2 (=Multi Line)
KD:
0 (=Line)
TN:
X
STN:
400
Assign desired station numbers to the corresponding DSS keys on the console. In this instance, KYNs
10-39 are used. The upper and lower 30 keys are associated with even-numbered port and odd-
numbered port respectively as shown in the following figure.
Page 318
Direct Station Selection (DSS) Console
even-numbered LEN level
fixed
to the subsequent LEN
fixed
Buttons 1-40 assignable
Enter the associated D
DSS/BLF station number
term
associated D
term
as a PL STN
term
station.
NEAX2400 IPX Feature Programming Manual
term
station number as the
NDA-24297, Issue 1
Advertisement
Table of Contents
