Table of Contents
Advertisement
T-5
Programming (cont'd)
T:
ICRT:
OGRT:
SFC:
IC PAD:
OG PAD: Outgoing PAD Data (1-15)
RT:
PAD DATA:
TLT (4W E&M)
1-2dB Pad On
2-4dB Pad On
3-6dB Pad On
4-8dB Pad On
15-PAD OFF
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ARTDN - Assign the TIE Line routes as shown below:
BOTHWAY LINES:
RT: 1
1-OSGS
6-TCL
Pad control is programmed in CDN 30:Pad. For DTI circuit cards, assign data "7", otherwise assign
data "0".
STEP 2:
APADN - Assign the Pad data required for the Tandem connection. Assign the following:
KIND:
T:
ICRT:
OGRT:
SFC:
IC PAD:
OG PAD: Outgoing PAD Data (1-15)
RT:
PAD DATA:
TLT (4W E&M)
1-2dB Pad On
2-4dB Pad On
3-6dB Pad On
4-8dB Pad On
15-PAD OFF
Page 744
TIE Line Connection With Pad Control
Tandem Connection
Incoming Route Number
Outgoing Route Number
Service Feature Class
Incoming PAD Data (1-15)
Route Number
[Not Used]
DTI
0-8dB Pad On
1-2dB Pad On
2-4dB Pad On
3-6dB Pad On
4-8dB Pad On
7-PAD OFF
:2
2-ONSG
:3
:4
7-L/T
:1
Kind of Connection
Tandem Connection
Incoming Route Number
Outgoing Route Number
Service Feature Class
Incoming PAD Data (1-15)
Route Number
[Not Used]
DTI
0-8dB Pad On
1-2dB Pad On
2-4dB Pad On
3-6dB Pad On
4-8dB Pad On
7-PAD OFF
[Not Used]
3-ISGS
:2
4-INSG
8-RLP
:2
15-LSG
[Not Used]
NEAX2400 IPX Feature Programming Manual
:3
5-TF
:3
:5
NDA-24297, Issue 1
Advertisement
Table of Contents
